Pdm Display; During Programmed Sample; Programmed Start Time Screen; Starting A Second Sample - Thermo Scientific 3600 PDM Manual

Using the WinPDM Software

PDM Display

PDM Display
During Programmed
Programmed Start
Time Screen
Starting a
Second Sample
To start a second primary
3-10 PDM 3600 Instruction Manual
The display on the top panel of the TEOM 3600 PDM allows users to
navigate through the instrument's firmware screens by pressing the "A" and
"B" buttons. But when the WinPDM communications software is used to
Sample
program a sample run, a user has no ability to change the parameters using
the "A" and "B" buttons.
Note After programming a sample using the WinPDM software, users
cannot stop the sample run by pressing the buttons on the PDM unit's
display. This feature allows users to complete compliance samples without
the risk of "prematurely" terminating a sample run. ▲
The Programmed Start Time screen
time that the PDM unit is scheduled to start a first programmed sample
run. This firmware screen will display on the PDM unit after you have
programmed a sample run. Users will not be able to display a different
firmware screen when the Programmed Start Time screen is visible on the
PDM unit.
Figure 3–10. Programmed start time PDM screen
The Programmed Start Time screen contains the following information:
Wearer ID 477 This field contains an 8-digit user-identification
●
number. This value can be set using the WinPDM software.
Start: This field contains the date (dd-mmm) and time (hh:mm) that
●
the PDM unit is scheduled to begin a programmed sample run. The
PDM unit will automatically begin a 35-minute warmup period before
this scheduled start time and date.
If the conditions change or the employees moves to a different area, a
second primary sample run can be started to run concurrently with the first
programmed sample run. Refer to Chapter 2 for more information on the
screens shown during a second sample run.
1. In the First Sample Screen #1, press the "A" and "B" buttons
sample run:
simultaneously to display the Reset Sample 2 screen
(Figure 3–10) displays the date and
(Figure
Thermo Fisher Scientific
3–11).