Sld-Conf - Bus Zone Assignment (2) - ABB RELION REB500 Engineering Manual

1MRK 511 452-UUS Rev. A
9.32

SLD-CONF - Bus zone assignment (2)

Note: For the initial configuration of a standard bus (single-line diagram), the bus zone
assignment is performed completely by the configurator tool.
For complex bus configurations, or for reconfiguration (extension) of existing setfiles,
it might be necessary to Reassign Buszones.
ANSI18000858 V1 EN-US
See
Distributed busbar protection REB500
Engineering manual
Section 5.5.2.
© 2020 Hitachi Power Grids. All rights reserved
Check Bus zone assignment
After pressing this button, the
software checks whether the bus
zone assignment is completed or
not.
→ The result of the check is
indicated in a separate window.
Annex B | Configurator mode - System configuration
GUID-48883315-F0A3-40F6-9B8E-B2BEC1BD7D0B v3
Section 9
81