Sld-Conf - Bus Zone Assignment (1) - ABB RELION REB500 Engineering Manual

Section 9
Annex B | Configurator mode - System configuration
9.31 SLD-CONF — Bus zone assignment (1)
ANSI18000857 V1 EN-US
See
80
(2) Bus zone assignment
Under this mode, the user can check
whether the system has (automatically)
assigned each busbar connector to a
bus zone.
Section 5.5.2.
© 2020 Hitachi Power Grids. All rights reserved
(1) Process bus zones mode
After the configuration of the
single-line diagram is finished,
switch over to the process
Process bus zones mode.
1MRK 511 452-UUS Rev. A
GUID-94ACBEC7-7838-4AF5-838D-82390F51F8A0 v3
Distributed busbar protection REB500
Engineering manual