Cu Device Creator (2) - ABB RELION REB500 Engineering Manual

Section 9
Annex B | Configurator mode - System configuration
9.35

CU device creator (2)

IEC18000861 V1 EN-US
84
The Build Process creates a new CU including the specified
hardware options:
 Redundant power supply on CU (or not)
 Power supply type (voltage range)
 Set the number of BIO boards (number of I/O's)
 Press Finish.
The Build Process completes now the configuration of the CU.
After the build process of the CU device creator was started once,
it can be repeated again (for example, to reflect subsequent
corrections resulting from system configuration changes).
© 2020 Hitachi Power Grids. All rights reserved
1MRK 511 452-UUS Rev. A
GUID-B427F50D-C0B0-414F-80C5-A7B19E713AE9 v2
Distributed busbar protection REB500
Engineering manual