Cu Device Creator (1) - ABB RELION REB500 Engineering Manual

1MRK 511 452-UUS Rev. A
9.34

CU device creator (1)

IEC18000860 V1 EN-US
See
Distributed busbar protection REB500
Engineering manual
Section 5.7.
© 2020 Hitachi Power Grids. All rights reserved
CU device creator
After the basic setfile configuration, the single-line diagram and the
bay configuration are completed, the design wizard for the Central
Unit (CU) shall be started.
 Press Next.
The hardware design wizard starts the configuration process
of a Central Unit suited for the bays (Bay Units) configured
under the single-line diagram.
In addition the CU specific hardware (settings) shall be
defined:
 Redundant power supply on CU (or not)
 Power supply type (voltage range)
 Set the number of BIO boards (number of I/O's)
 Press Next.
Annex B | Configurator mode - System configuration
GUID-2B881384-B924-4FAE-A98E-0C398157C0E7 v2
Section 9
83