Network - ABB RELION REB500 Engineering Manual

1MRK 511 452-UUS Rev. A
IEC18000581 V1 EN-US
Figure 13:
5.8

Network

This menu contains an overview of the BU device Id's. Since the CU device creator process (see
Section
are usually not necessary. If required (for example, for reordering the bays after initial
engineering), the ID can be adjusted manually, taking care that IDs have to be unique and can only
be used once.
Distributed busbar protection REB500
Engineering manual
CU Hardware wizard/ finish HW build process
Once the build process of the CU device creator is completed, it can be repeated
again (for example, to reflect subsequent corrections resulting from system
configuration changes).
See Section 9.36.
5.7) performs the complete network assignment (physically and logically), manual changes
© 2020 Hitachi Power Grids. All rights reserved
IEC18000581-IEC18000581-1-en.vsdx
GUID-C6C951BA-AC72-425D-A1AF-1554B0BB6955 v2
Section 5
Configuration
29