Service/Maintenance Guide - Supreme 100; Service/Maintenance Guide - Supreme 150 / Performer 150 / Supreme 250 / Performer 250 / Supreme Lcd - Nilfisk-Advance Supreme 100 EU Instructions For Use Manual

10.1 Service/maintenance guide - Supreme 100

NB! Never vacuum without a fi lter and dust bag installed in the model Supreme 100
Product How often?
Dust bag Should be replaced
before it becomes
completely full, de-
pending on use but
normally 2-4 times a
year.
Filter in Should be checked
bottom when changing the
bag.
10.2 Service/maintenance guide - Supreme 150 / Performer 150 /
Supreme 250 / Performer 250 / Supreme LCD
NB! Never vacuum without a fi lter installed.
Product How often?
Dust Should be emptied
container before the container
is 3/4 full, depending
on use but normally
2-4 times a year.
Dust bag Should be replaced
before it becomes
completely full, de-
pending on use but
normally 2-4 times a
year.
Filter Should be shaken
when the container is
emptied.
NB: Only use dry
cleaning methods
Original Instructions
Why? How?
Poor suction Grasp the edge of the lid and open it by pulling upwards. Re-
and danger move the old dust bag by turning the cardboard stiff ener to
of creating a the right or left so that the elevation on the nozzle penetrates
blockage in the the opening in the cardboard. Now slide the bag off the inlet.
pipe system. Push the opening in the cardboard over the elevation on the
inlet and pull on the new bag. Twist the cardboard to lock the
bag in place. NB! The opening in the card must be adjusted
and pushed past the elevation on the inlet before the card-
board can be locked into place with a twisting action.
NB! Never vacuum without a dust bag installed.
Poor suction Remove the dust bag as described above. Remove the
can result. Dust fi lter from the bottom. The fi lter can be cleaned by shaking
can fi nd its way it or washing it in water. NB! The fi lter must be completely
into dry before being reinstalled. Replace the cleaned fi lter
the motor. in the machine. Press the outer edge of the fi lter down
against the sides of the container so that the fi lter bulges
up slightly. Refi t the dust bag and replace the lid. Check
that the lid is sitting fi rmly in place.
NB! Never vacuum without a fi lter installed.
Why? How?
Danger of Release the two handles clamping the dust container.
blockage in the The handles are easily unlocked by lifting up the handles
pipe system. until they come to a stop. When you pull the handles out-
wards away from the cleaner, the container is released.
Lift off the container. Lift out the fi lter and dust bag - see
additional information below. Empty the dust into a plas-
tic bag and put in dustbin. Any remaining dust or fl uff can
be removed manually.
Poor suction Release the two handles clamping the dust container.
and danger The handles are easily unlocked by lifting up the handles
of creating a until they come to a stop. When you pull the handles out-
blockage in the wards away from the cleaner, the container is released.
pipe system. Lift off the container. Lift out the fi lter. Then remove the
dust bag by pulling the bag's cardboard stiff ener off the
nozzle. Replace in reverse order.
To maintain Release the two handles clamping the dust container.
good suction The handles are easily unlocked by lifting up the handles
power. until they come to a stop. When you pull the handles out-
wards away from the cleaner, the container is released.
Lift off the container. Do not remove the fi lter from the
container. Instead, give the fi lter a light shaking inside
the container to loosen dust from the fi lter and allow it to
fall into the container. Lift out the bag fi lter. If a dust bag
is being used - remove it. Then empty the dust from the
container in a suitable place.
51