Electrical Connection - Nilfisk-Advance Supreme 100 EU Instructions For Use Manual

8 Electrical connection

On/Off
The control current outlet (low voltage) is connected to a
control current lead running the length of the pipes. Both
ends of the low-voltage lead are connected to the connec-
tion panel on the vacuum unit. One lead to each outlet.
The low-voltage lead should be connected as informed
below.
Location of the outlet for the low-voltage cables:
Supreme 100
Supreme 100
The connection panel is
located in the bottom of
the vacuum unit.
Connection of the low voltage cables
The low voltage cables that runs along the pipes, is to
be connected to the connector at the vacuum cleaner.
Connect the ends of cables in the electrical sockets, one
cable end in each socket. Secure the low voltage cables
by pulling the snap lockings at the connector, downwards.
Secure the low voltage
cables at the connector
- pull the snap lock-
ings at the connector
downwards.
Low voltage cable
48
Supreme 150 /
Performer 150 /
Supreme 250 /
Performer 250 /
Supreme LCD
The connection panel is
located in the top of the
vacuum unit
Connector
Connection panel
All models have the low voltage cable connector placed
to the left on the panel. These models do also have two
extra outlets on the panel. These outlets are prepared for
future functions and are not in use for the moment. The
connector for the cable to the transceiver box is placed to
the right.
Originlal Instructions