Filter And Dust Bags - Supreme 100; Replacing The Dust Bag; Replacing / Cleaning The Fi Lter - Nilfisk-Advance Supreme 100 EU Instructions For Use Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

4 Filter and dust bags - Supreme 100

4.1 Replacing the dust bag

The central vacuum cleaner is fi tted with a dust bag as
standard; never vacuum without a dust bag installed.
Grasp the edge of the lid and pull upwards to open it, Fig. 11.
Replacing the dust bag: Remove the old dust bag by
turning the cardboard stiff ener to the right or left so that
the raised part of the inlet is in line with the opening in the
card. Now slide the bag off the bag nozzle.
Fit the new dust bag as follows: Push the opening in the
cardboard over the elevation on the inlet and pull on the
new bag. Turn the cardboard to lock the bag in place. NB!
Turn the edges of the dust bag down into the container.
This is to avoid damaging the bag with the lid.
The cardboard stiff ener locks the bag in place when you
twist it as shown in Fig. 12 above.
The opening in the card must line up and slide over the
elevation on the inlet before you twist the cardboard stif-
fener to lock it.
Original Instructions
Fig. 11
Fig. 12
Fig. 13
4.2 Replacing / cleaning the fi lter
Open the lid and take out the dust bag as described
earlier. The fi lter sits at the bottom of the container around
the motor housing. Never use the central vacuum clea-
ner without a fi lter installed.
Pull the fi lter out of the container, Fig. 13. The fi lter can be
cleaned by shaking it or washing it in water.
If you wash the fi lter, you must let it dry completely
before refi tting it.
Take the cleaned/new fi lter and place it in the bottom
of the container. Press the outer edge of the fi lter down
against the sides of the container so that the fi lter bulges
up slightly. Then push the fi lter down into place. Make
sure the fi lter is packed in tightly against the motor hou-
sing, Fig. 14. Reinstall the dust bag and replace the lid.
Check that the lid is fi rmly secured.
Motor housing
Filter
Fig. 14
Filter
43

Advertisement

Table of Contents
loading

Table of Contents