Supreme Lcd Display - Nilfisk-Advance Supreme 100 EU Instructions For Use Manual

6.3 Supreme LCD Display

The Supreme LCD model has a display giving information
about the machine, Fig. 21.
Airflow
Wireless Temperature
Dustbag/Filter
Speed level
When the start button is pushed or the hose is
connected to the wall socket, the display will turn on
and show the speed level.
Dust bag/bag fi lter indicator
When the dust bag/fi lter symbol starts to fl ash dur-
ing operation, the cleaner tells you that it is almost time
to clean the bag fi lter and replace the dust bag. When it
is time to do so, symbol will be lit continuously. The dust
bag/fi ler symbol will be lightened after every 20 operation
hours of the cleaner at the latest. If the symbol is lit, do
like this: Turn off the cleaner by the hose handle (remote
versions) or remove the suction hose from the wall inlet
(manual hose versions) or by pushing the on/off switch
on the display. Then check if the bag fi lter/dust bag is
clogged. Replacement is described in chapters 7.1, 7.2,
7.3 and 7.4.
In switched off mode, re-set run time counter by holding
the start/stop button down until the dust bag indicator
goes out (after approx. 5 sec.).
Reduced airfl ow indicator - lit
The reduced airfl ow symbol on the display indi-
cates that the airfl ow through the vacuum cleaner
is reduced. After 30 seconds of operation with
reduced airfl ow, the vacuum motor will be shot down in or-
der to prevent damage to the motor. If the reduced airfl ow
symbol is lit and the motor has been shut down, do like
this: Check the bag fi lter and dust bag (see chapters 7.1,
7.2, 7.3 and 7.4) to see if anything is blocking the airfl ow.
Remove the material causing the reduced airfl ow symbol
to indicate.
Service indicator
When the service symbol starts fl ashing, the mo-
tor will run for one more hour before it stops/will
not start. The purpose of the service symbol is to inform
you that it is time to order service of the cleaner. When
the symbol is continuously lit, the run time counter in the
cleaner has counted that the allowed amount of run time
has passed. You must now contact an authorised service
workshop and let them perform a service of the cleaner
and to reset the run time counter.
46
Fig. 21
Service
Speed
Overheat indicator - fl ashing
The overheat symbol indicates that the cleaner has
become overheated. The cleaner stops automati-
cally. Unplug the main power cord to reset the vacuum
cleaner and wait 5-10 minutes to allow the machine to
cool down. While you are waiting, check the hose, dust
bag and fi lter to be sure that nothing is blocking the fl ow
of air through the machine.
Signal indicator - fl ashing
When the symbol is fl ashing, the hose handle is out
of range and there is no connection to the cleaner.
The cleaner will automatically stop after 30 min. if
the hose handle or the cleaner has not been activated.
Originlal Instructions