Table of Contents
Advertisement
The appliance is suitable for picking up dry, non-
flammable dust, non flammable liquids, sawdust and
hazadous dusts with OEL
Dust Class M (IEC 60335-2-69).
The dusts which belong to this
class are: dusts with OEL values
> 0.1 mg/m³ as well as saw dust. The machine is
tested in its entirety by vacuums for this dust class.
The maximum degree of permeability is 0.1% and
the disposal must be low dust.
For dust extractors, ensure adquate air change rate
M, when the exhaust air is returned to the room.
Observe national regulations before use.
1.4
Electrical connection
•
It is recommended that the machine should be
connected via a residual current circuit breaker.
•
Arrange the electrical parts (sockets, plugs and
couplings) and lay down the extension lead so
that the protection class is maintained.
•
Connectors and couplings of power supply
cords and extension leads must be watertight.
1.5
Extension lead
1. As an extension lead, only use the version
specified by the manufacturer or one of a higher
quality.
2. When using an extension lead, check the mini-
mum cross-sections of the cable:
Cable lenth
up to 20 m
20 to 50 m
1.6
Guarantee
Our general conditions of business are applicable
with regard to the guarantee.
Unauthorised modifications to the appliance, the use
of incorrect brushes in addition to using the appli-
ance in a way other than for the intended purpose
exempt the manufacturer from any liability for the
resulting damage.
1.7
Important warnings
WARNING
• To reduce the risk of fire,
electric shock, or injury,
please read and follow
all safety instructions
and caution markings
before use. This ma-
chine is designed to be
safe when used for
OEL=Occupational Exposure Limit,
1)
Original instruction
1)
values > 0.1 mg/m³
Cross section
< 16 A
< 25 A
1.5 mm
2
2.5 mm
2
2.5 mm
4.0 mm
2
2
Optional accessories / Option depending on model
*)
cleaning functions as
specified. Should dam-
age occur to electrical or
mechanical parts, the
1)
machine and / or acces-
sory should be repaired
by a competent service
center or the manufac-
turer before use in order
to avoid further damage
to the machine or physi-
cal injury to the user.
• Do not leave the ma-
chine when it is plugged
in. Unplug from the
socket when not in use
and before mainte-
nance.
• Outdoor use of the ap-
pliance shall be limited
to occasional use.
• Do not use with dam-
aged cord or plug. To
unplug grasp the plug,
not the cord. Do not
handle plug or machine
with wet hands. Turn off
all controls before un-
plugging.
• Do not pull or carry by
cord, use cord as a
handle, close a door on
cord, or pull cord around
sharp edges or cor ners.
Do not run machine over
cord. Keep cord away
from heated surfaces.
• Keep hair, loose cloth-
ing, fingers and all parts
3
Advertisement
Table of Contents
