Filter And Dust Bags - Supreme 100; Replacing The Dust Bag; Replacing / Cleaning The Fi Lter - Nilfisk-Advance Supreme 100 Instructions For Use Manual

Vacuum cleaner
Table of Contents

Advertisement

Available languages

Available languages

4

Filter and dust bags - Supreme 100

Fig. 12

4.1 Replacing the dust bag

The central vacuum cleaner is fi tted with a dust bag as
standard; never vacuum without a dust bag installed.
Replacing the dust bag: Grasp the edge of the lid and
pull upwards to open it, Fig. 12. Remove the old dust bag
by turning the cardboard stiffener to the right or left so that
the raised part of the inlet is in line with the opening in the
card. Now slide the bag off the bag nozzle.
Fit the new dust bag as follows: Push the opening in
the cardboard over the elevation on the inlet and pull on
the new bag. Turn the cardboard to lock the bag in place.
NB! Turn the edges of the dust bag down into the contain-
er. This is to avoid damaging the bag with the lid.
Fig. 13
The cardboard stiffener locks the bag in place when you twist it
as shown in Fig. 13 above.
The opening in the card must line up and slide over the elevation
on the inlet before you twist the cardboard stiffener to lock it.
8
Fig. 14
4.2 Replacing / cleaning the fi lter
Open the lid and take out the dust bag as described earli-
er. The fi lter sits at the bottom of the container around the
motor housing. Never use the central vacuum cleaner
without a fi lter installed.
Replacing the fi lter:
Pull the fi lter out of the container, Fig. 14. The fi lter can be
cleaned by shaking it or washing it in water.
If you wash the fi lter, you must let it dry completely
before refi tting it.
Fit the fi lter as follows: Take the cleaned/new fi lter and
place it in the bottom of the container. Press the outer
edge of the fi lter down against the sides of the container
so that the fi lter bulges up slightly. Then push the fi lter
down into place. Make sure the fi lter is packed in tightly
against the motor housing, Fig. 15. Reinstall the dust bag
and replace the lid. Check that the lid is fi rmly secured.
Fig. 15
Motor housing
Filter
Filter

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents