WSS100 - WST100 DV Table of contents Instructions for use ......................2 Operator’s safety ..........................2 General recommendations ......................2 Vacuum cleaner description...................3 Labels .............................. 3 Packing and unpacking ........................3 Setting up - connection to the power supply ................... 4 Vacuuming liquids ...........................
WSS100 - WST100 DV Instructions for use Read the operating instructions and comply with the important safety recommendations identified by the word WARNING! Operator’s safety General recoinendations WARNING! WARNING! Before starting the vacuum cleaner, it is Risk of fire outbreaks and explosions. absolutely essential to read these operating •...
Controls (switches) Model A (in) B (in) C (in) Inlet Vacuum motors WSS 100 Liquid container closing band WST 100 DV Diverter valve control (WST 100 DV only) Liquid level indicator tube Drain valve Safety filters Float for stopping liquids (located under chip basket)
WSS100 - WST100 DV Setting up - connection to the power supply WARNING! The vacuum cleaner’s power socket must be protected WARNING! by a differential circuit-breaker with surge current • Make sure that the vacuum cleaner is in good limitation, that shuts off the power supply when the condition before starting work.
WSS100 - WST100 DV Vacuuming Liquids Technical specifications WSS 100 / WARNING! Parameter Units WST 100 DV Comply with the safety regulations governing the Voltage / frequency V/Hz 120/60 materials for which the vacuum cleaner is used. Power rating WARNING!
Figure 7 ON/OFF switches Diverter valve (WST 100 DV only) Drain valve Emptying the liquid container (WSS 100) Figure 1 • When the tank is full, the float (11-figure 1) stops the vacuuming operation; nevertheless, the vacuum motors (5-figure 1) remain activated.
Chip basket WARNING! Container closing band Motorhead (WST 100 DV) The precautions described below must be taken during Motorhead (WSS 100) all the maintenance operations, including cleaning and replacing of the safety filters. WARNING! • To allow the user to carry out the maintenance...
WSS100 - WST100 DV Cleaning the containers Cleaning or replacement of the safety filters WARNING! Figure 10 Before proceeding with these operations, turn off the Safety filters vacuum cleaner and remove the plug from the power Separator socket. Filter cover Chip Basket •...
WSS100 - WST100 DV Vacuum cleaner disposal Wiring diagrams Dispose of the vacuum cleaner in compliance with the laws in Wiring diagram list - fig. 14 force. Reference Part number The symbol (figure 13), which is present on the product or Armature in its documentation, indicates that the product cannot be disposed of together with other domestic waste at the end of...
WSS100 - WST100 DV Troubleshooting Problem Cause Remedy The vacuum cleaner suddenly stops. Activation of the level monitoring Emptying of the liquid container. system. Intervention of thermal protection Push the switches to stop the vacuum devices. cleaner, wait until the motors cool down, then start it again.