Operating Instructions; General; Pre-Operation Check - Can-Am DS250 Operator's Manual

OPERATING INSTRUCTIONS

General

Transmission lever must be on NEU-
TRAL to allow engine starting.
To start engine, place the engine stop
switch to RUN position, insert key in
ignition switch and turn to the ON po-
sition then press the engine start but-
ton.
NOTE: For your convenience, an over-
ride mode allows the engine to be
started with the transmission lever in
any position. Press and hold the front
brake lever while pressing the engine
start button.

Pre-Operation Check

WARNING
The pre-operation check is very
important prior to operating the
vehicle. Always check the prop-
er operation of critical controls,
safety features and mechanical
components before starting.
not done as specified here, severe
injury or death might occur.
Before using this vehicle, the operator
should always:
– Apply parking brake and check if it
operates properly.
– Check tire pressure and condition.
– Check wheels and bearings for
wear and damage.
– Check location of controls and en-
sure they work properly.
– Verify if steering operates freely.
– Activate throttle control lever sever-
al times to ensure it operates freely.
It must return to idle position when
released.
______________________
80
– Activate the brake levers and brake
pedal to make sure the brakes fully
apply. Levers and pedal must fully
return when released.
– Ensure transmission lever is work-
ing then reset in NEUTRAL position.
– Check drive chain for adjustment
and lubrication.
– Check sprockets for wear and dam-
ages.
– Check tightening of rear axle fasten-
ers.
– Check swing arm, if any lateral play
is detected DO NOT USE THE VE-
HICLE.
– Check fuel, oil and coolant levels.
– Check for oil leaks on the engine
and gearbox.
– Ensure fuel valve is in fully open
position (ON).
– Clean headlamps and taillight.
– Ensure front access compartment
cover is properly latched.
If
– Ensure seat is properly tightened.
– If you transport cargo, respect load
capacity.
– If you are pulling a trailer or other
equipment, ensure it respects the
tongue capacity and towing capac-
ity. Ensure trailer is properly se-
cured to hitch.
– Look and feel for loose parts while
engine is off. Check fasteners.
– Ensure the path of travel is free of
persons and obstacles.
– Check operation of ignition switch,
engine start button, engine stop
switch and headlamps.
– Start engine, remove parking brake
and drive forward slowly a few feet
then apply all brakes individually to
test them.