Advertisement
Instructions for kit #DH77K
21. Dividers:
The hall is narrow and finishing around or in front of the
stairs is hard. The 13" Divider (the one next to the stairs)
must be installed and finished (paint or wallpaper) and the
flooring must be done before installing the stairs - and I
recommend also finishing the front of the tower (including
window trim) before the stairs but not permanently install-
ing the 2-Door Dividers until after the Stairs and Banisters
have been completed. It is possible to build the Stairs, Banis-
ter, and Landing Rails without gluing them into the house.
• If you haven't already done so, square the corners of
the stair holes. Use a utility knife or coarse double-cut
file, and work from both surfaces toward the center to
avoid "split out": two cuts from each direction for each
corner.
Glue: top, bottom, front
Push the rest of the way in
Stair Block
Tip - almost all the way in,
Set the base on the mark
Straighten to the stair hole
Glue
nstall the 13" Dividers.
I
Mark
Lift the next higher floor
Stand upright to the mark
Line up everything again
Let the glue dry
page 24
Top Block
Lined up with Wall G
Lined up with Stair hole
Lined up up-and-down
Mark the floors' edges
Mark
Advertisement
