Advertisement
Instructions for kit #DH77K
□
7A. Prepare a flap of tape on the bottom of each Front Roof to stick
out diagonally at the corner and to the back.
B. Glue and tape the Side Roof to the back of the Front Roof, lined up on
the outside (angled) edges, and flat at the top.
C. Temporarily put a Rooftop against the inside to hold the Roofs square
as the glue dries.
Glue and tape
□
8A. Test assemble the tower room (withoug glue) using the Tower
Sides marked and painted in Pre-Assembly (15
3
5
3
Wall E
/
||.
4
8B. Position the Tower Room lined up with the back of the Top Floor,
lined up with the Stair Hole on the inside, and lined up at the front corner
with the corners below it.
Important: Lay the Rooftops flat on the floor lined up with the rear edge
to square the Tower Walls with the back edge of the Top Floor.
Line up with the Stair Hole
8C. Position the Roofs on the Top Floor, with the Side Roofs lined up in back and parallel
to the edge of the floor, and with the Front Roof located with the Attic Divider.
Attic Divider is
lined up in back
B
Let the glue dry - then take off the tape
Tower Room Assembly
7
/
3
5
/
4
8D. Trace around the Roofs and Tower,
move everything out of the way, and
paint to just cover the line.
Side Roof
Flat at the top
8
One-Door Dividers) and
in front and in back
A
the back of the Front Roof
Rooftop
Line up the Corners
Tower page 15
C
Lined up in back
Rooftop used as a
Square
Advertisement
