Advertisement
Instructions for kit #DH77K
9. Temporarily, set Dividers between each floor to hold them straight.
Glue, tape, and weight the Tower Wall set to the Top Floor, located as you
did in step 8.
Lined up
10. Set the Attic Divider close to the Tower Side (leave room for glue
squeezings), lined up at the back of the Top Floor. Glue, tape, and weight
the Roof set for that side, Lined up in back, parallel to the floor's edge, and
tight to the Attic Divider.
Tape
Tight
Tape
When the glue is dry enough to you can move the Attic
Divider without things moving, repeat the steps for the
other Roof set.
Lined up
Parallel
Lined up
Lined up
in back
Tape
Square
Attic Divider
Lined up in back
Tape and weight to make everything tight
Roofs page 16
3
5
/
in back
4
Advertisement
