Advertisement
Instructions for kit #DH77K
Wiring? If you are going to wire your house, be prepared to cut slots for the tapewire each time a
floor is ready to glue down. An Oscillating Multitool makes running wire later just as easy but for
builders who will be cutting slots with a rotary tool or 'drilling and carving', follow the tracing (in
the PreAssembly step) and cut the hole 5
sticking out from the inside wall's surface
go up one side, across the rooftop, and down the other side all in one piece (no connections means a
more robust 'main loop', which is the backbone of any wiring layout). www.DollhouseWiring.com
Housebody Assembly:
the Foundation and Base Floor
□
1. Glue, tape, and weight the Base Floor to the
Foundation set, lined up at the back edge, and spaced
evenly side-to-side.
Weight the Base and Foundation set to lay abso-
lutely flat on a flat worksurface as the glue dries. Getting
the Base assembly flat is necessary for a flat house!
Set Up the Walls
□
2A. Tape together the 1st floor's left wall set using the wall sizes
and bevels shown. Make sure the clapboard is right-side-up.
this is a bevel notation
A|/
B\/
Left Wall set:
Inspect the Bevels
1
/
" from the back edge, mostly hidden by the wall, and
2
1
/
" or so. Cut two slots in each Floor so the tapewire can
32
When the glue is dry, take off the tape
Clean any paint on the
edges or inside face
C\/
B\/
A|/
1
16
/
8
5
4
/
Lined up evenly side-to-side from front to back
C\/
D\\
C\/
B\/
7
6
/
16
8
Foundation and Base Floor page 10
D\\
9
4
/
16
D\\
Advertisement
