Advertisement
Instructions for kit #DH77K
□
3D. Stand Dividers to hold Walls G and H straight.
Weight the Right Side Walls. Let the glue dry.
□
3E. Trim, scrape and sand (100 grit taped to a
sanding block) the insides and corners of the walls
and Floor. It will never be easier to clean and prepare
the interior of the walls for wallpaper and paint.
Trim
Wiring? Trace and cut slots for the Main Loop in the next floor before you glue on.
□
4. Glue, tape, and weight an Upper Floor
to the walls, centered (
3
/
lined up in back..
Avoid smearing: Have a helper hold up the front
edge while you line up and center the back edge
side-to-side. Hold the back edge in place while
your helper lays down the front edge.
Lined up in back
Temporary use of Dividers
to hold the walls straight
Let the glue dry - then take off the weights and tape
8
") side-to-side and
Let the glue dry - then take off the weights and tape
Without glue, tape Dividers across the back to support the back
edge of the middle floor while it is being glued to the Walls, and to
hold the Side Walls straight.
Scrape
Temporary use of Dividers
to hold the walls straight
Don't glue temporary Dividers
Weight
Walls and Floors
Weight
Tape
c
3
entered (
/
") side-to-side
8
Clean up
excess glue
page 13
Advertisement
