Operation; Care And Maintenance - Power Fist 8835548 Manual

8835548
4. Repeat with three more screws. Tighten all screws until the gap
between the press base and the bench top is 1/8 in.

OPERATION

Loosen the knob (#2) and adjust the handle's length (#4) for greater
1.
leverage, then tighten the knob (02#) to secure the handle.
2. Mount accessories onto the press (see accessory's manual).
a. Do not install accessories to use as an arbor press.
3. Insert the workpiece between the upper and lower accessory or
between the ram and work table.
4. Rotate the handle down to apply pressure to the workpiece. Extend
the handle length to increase the force on the workpiece.
5. Rotate the handle up to release the workpiece.
6. Repeat until the task is complete.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool clean, dry and free from oil/grease at all times.
6. Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
LUBRICATION
Inspect and lubricate the tool when required. Only use light oil to lubricate
the tool. Other lubricants may not be suitable and could damage the tool or
cause a malfunction during use.
When not in use for an extended period, apply a thin coat of lubricant to the
steel parts to avoid rust. Remove the lubricant before using the tool again.
6
3 Ton Multi-Function Fabrication Press
For technical questions call 1-800-665-8685
V1.0