Table of Contents
Advertisement
Available languages
Available languages
V1.0
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the contents are included.
Contents: • Fabrication Press • Handle • Knob • Handle Sleeve (2)
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
PRESS ASSEMBLY
1.
Insert the handle (#4) through the hole of gear (#3).
2.
Slide a handle sleeve (#5) onto the end of each handle and push down
to firmly seat each one.
3.
Screw the knob (#2) into the end of the gear (#3).
MOUNT TOOL ON A PEDESTAL
The hardware to mount tool is not included. The pedestal must be secured
to the floor to prevent it from tipping over.
1.
Align the tool's mounting holes with the corresponding pedestal holes.
2.
Slide a flat washer over a 1/4-20 x 1 in. hex head bolt and insert
through press base and pedestal holes.
3.
Slide a 1/4 in. flat washer over the end of the bolt and screw a 1/4-20 in.
hex nut onto the bolt end. Tighten until the space between the tool's
base and pedestal is 1/8 in.
4.
Screw a second nut onto the bolt and secure against the first. This will
prevent them from loosening due to the tool's vibration.
5.
Repeat steps 1 to 4 for the other three bolt holes.
MOUNT TOOL ON A WOOD WORKBENCH
The hardware to mount the tool is not included.
1.
Clean the work area where the tool will be mounted.
2.
Position the tool, check that it will be level and there are no
obstructions around it that will interfere with a long workpiece.
3.
Slide a flat washer over a 1/4 x 1 in. wood screw and secure the press in
place.
Visit www.princessauto.com for more information
3 Ton Multi-Function Fabrication Press
8835548
5
Advertisement
Table of Contents
