Table of Contents
Advertisement
Available languages
Available languages
V
1.0
OPERATION
BEFORE FIRST USE
Before the first use, check for proper hydraulic oil level in the system. Then
thoroughly test the hydraulic ram for proper operation prior to its actual use.
1.
Purge air from the hydraulic system. See Bleeding the Hydraulic System in
the Maintenance section.
OPERATING THE SHOP PRESS
WARNING! Ensure that you read, understand and apply the safety instructions
and warnings before use.
1.
Place the heel blocks (#4) on the bed frame (#6), then insert a workpiece
on the heel blocks.
2.
Lift or lower the bed frame until it is in position. Insert a bed frame pin (#8) on
the left and right posts beneath the bed frame. Lower the bed frame so it
rests on the pins. Insert the circlips (#7) on the ends of each pin.
3.
Close the release valve by turning it clockwise until it is firmly closed.
4.
Pump the handle (#43) until the serrated saddle nears the workpiece.
5.
Align the workpiece and ram to ensure center-loading.
6.
Pump the handle to apply load onto the workpiece.
7.
When the work is done, stop pumping the handle. Slowly and carefully
remove load from workpiece by turning the release valve
counterclockwise in small increments.
8.
Once the ram has fully retracted, remove the workpiece from the bed frame.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Only use accessories intended for use with this tool.
5.
Keep the tool handles clean, dry and free from oil/grease at all times.
6.
Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
Visit www.princessauto.com for more information
8911323
7
Advertisement
Table of Contents
