Table of Contents
Advertisement
TROUBLESHOOTING
SYMPTOM
Machine does not turn on
Noisy Operation
Chuck or quills fall out
Spindle does not move up or
down
Spindle does not rotate
977701V
CAUSE
Machine not plugged in
Frequency drive has an error
Too long or not correct
extension cord
Emergency stop button is
activated
Belt cover is open
Incorrect belt tension
Loose spindle or motor pulley
Spindle bearing worn
Rust inhibitor, dirt, debris in
or on quill or spindle taper
Belt is broken or slipping
Debris in quill
Feed depth adjustment is set
Belt tension is too loose
Belt is broken or worn
Taper is slipping in spindle
Motor is not rotating
18
Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
www.dakecorp.com
SOLUTION
Plug in to proper receptacle
Clear error by turning drill off
and back on
Remove extension cord and
plug directly in to receptacle
Deactivate emergency button
Close belt cover
Adjust tension, see "Speed
Adjustment" section of this
manual
Check for wear or if pulley
can be tightened
Replace bearing
Clean chuck and quill
Check belt for damage and
replace if needed. Check for
proper belt tension, see
"Speed Adjustment" section
of this manual
Clean quill and teeth
See "Feed Depth Adjustment"
in this manual
Tighten belt tension, see
"Speed Adjustment" section
of this manual
Replace belt
Clean chuck and quill
Troubleshoot motor or
contact DAKE
REV122021
Advertisement
Table of Contents
