Table of Contents
Advertisement
WORK HOLDING
When drilling directly on the table surface it is recommended that a piece of wood or plywood be
clamped securely to the table under the work piece. This will minimize splintering or burring as
the drill breaks through the work. It will minimize drill bit and table damage. Clamp work piece to
the table whenever possible. The table has "T-slots" that allow for many different clamping
configurations. When part cannot be affixed to the table a drill vise that is bolted to the table
must be used to hold the work piece safely.
SPEED ADJUSTMENT
WARNING: Wait until the machine has come to a complete stop before proceeding
with changing the speed!
1. With motor running (NOT ON THE HIGHEST SPEED), adjust the range change handle
and at the same time move the adjustment handle to the desired range. See illustration
and speed chart.
977701V
14
Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
www.dakecorp.com
REV122021
Advertisement
Table of Contents
