Table of Contents
Advertisement
TABLE SWING ADJUSTMENT
1. To swing the table up to 360°, loosen the clamp release bolt and swing the table to the
desired position.
2. After table is in the correct position, tighten clamp release bolt securely.
Note: Never swing the table if any material or fixturing is on it. Only adjust when table is free
of loose articles.
FEED DEPTH ADJUSTMENT
1. Setting the feed depth adjustment is done by loosening the depth locking handle on the
spindle depth index sleeve.
2. Rotate to desired length,
a. The straight zero point is for manual depth operations.
b. The zigzag zero point is for auto feed depth operations.
3. And securely tighten the depth locking handle.
Note: Never make this adjustment while machine is running.
977701V
13
Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
www.dakecorp.com
REV122021
Advertisement
Table of Contents
