Connect/Disconnect The Cables - Pilz PSSu K F EI Operating Manual

Wiring
6.2

Connect/disconnect the cables

We recommend you use a screw driver with a 0.4 x 2.5 mm (DIN 5264) blade!
Strip the cable:
}
Strip the cable [1] and apply a ferrule if necessary (DIN 46228/Part 1 or DIN 46228/Part
4).
Connect cable:
}
Using the screwdriver, press the actuator button on the spring-loaded terminal down as
far as it will go [2], keep it held down and insert the stripped cable into the plug connec-
tion as far as it will go [2].
}
Check that the cable is firmly seated [3].
Disconnect cable:
}
Using the screwdriver, press the actuator button down as far as it will go [4], keep it held
down and pull the cable out of the plug connection [4].
Fig.: Connect and disconnect the cables
Operating Manual PSSu K F EI
1003303-EN-03
[1] [2] [3] [4]
| 43