Extreme Networks ExtremeSwitching SLX 9250 Hardware Installation Manual page 52

Installing a 750 W Internal AC Power Supply
c. Open the clip and slip it over the barrel of the connector.
The diagram below - Power Supply with Power Cord and Retainer Attached shows the power
supply with the power cord and retainer in place.
Figure 23: Power Supply with Power Cord and Retainer Attached
d. Snap the clip firmly around the connector.
7. Connect the other end of the power cord to an AC power outlet.
To install a second power supply, repeat this procedure.
When you are finished, follow the steps in
52 ExtremeSwitching SLX 9250 Hardware Installation Guide
Warning
Always make sure that the source outlet is properly grounded before plugging the AC
power cord into the AC power supply.
Powering up the Switch on page 57 .
Installing Your Switch