3-4
Connectors
This section gives an overview of the connectors located at the base layer of the IPC Machine Control-
ler.
3-4-1
Power Connector
The power connector on the Panel PC is used to supply 24 VDC power to the Panel PC.
The power connector is supplied with the Panel PC.
Additional Information
• Refer to 4-2-1 Power Connector Specifications on page 4-12 for specifications.
• Refer to 5-4-3 Wire the Power Connector on page 5-34 for wiring details.
• Refer to 5-5 Connect on page 5-40 for connection details.
3-4-2
I/O Connector
The I/O connector on the IPC Machine Controller provides discrete signals with the following func-
tions.
• Input signal to the Panel PC when a connected UPS switches to battery power.
• Input signal to the Panel PC to perform a shutdown or power ON when the signal turns ON.
• Output signal from the Panel PC to indicate the power status of the Panel PC.
The I/O connector is supplied with the Panel PC.
NY-series Industrial Panel PC Machine Controller Hardware User's Manual (W557)
3 Hardware Overview
3-15
3