Clean The Touchscreen Surface - Omron SYSMAC NY Series Hardware User Manual

Periodically but at least every 6
months
For a cooling layer with removable
cover:
•
Check the battery replacement
date on the label at the inside of
the Cover.
•
Replace the battery before the
replacement date.
Check the backup and repair me-
dia.
When the IPC Machine Controller
is not powered for 6 months
For a cooling layer with removable
cover and active cooling:
•
Confirm both fans rotate immedi-
ately after Power ON.
•
Replace the Fan Unit when the
fans do not rotate smoothly.
7-1-2

Clean the Touchscreen Surface

Clean the touchscreen surface of the IPC Machine Controller when necessary to keep it in the best
operating condition.
• Ensure the IPC Machine Controller is OFF before cleaning.
• Wipe the IPC Machine Controller daily with a dry, soft cloth. If the touchscreen is very dirty and you
try to clean it with a dry cloth, you may scratch the surface. Use a damp cloth first to remove the dirt.
• When a spot cannot be removed with a dry cloth, dampen the cloth with a neutral cleanser, wring
out the cloth and wipe the touchscreen surface.
• Remove all residue from gum, vinyl or tape when cleaning.
Precautions for Correct Use
Turn OFF the product or disable the touchscreen for cleaning.
Additional Information
Allowed cleaning materials for the touchscreen surface:
• Isopropyl alcohol
• Detergents between pH 5 and pH 8
Rinse with demineralized water after cleaning
• Demineralized water
NY-series Industrial Panel PC Machine Controller Hardware User's Manual (W557)
•
Refer to 7-2-1 Remove the Cover on page 7-6 to check the label.
•
Refer to 7-2-3 Replace the Battery on page 7-9 to replace the bat-
tery.
Refer to the NY-series IPC Machine Controller Industrial Panel PC / In-
dustrial Box PC Setup User's Manual (Cat. No. W568) for Rescue Disk
details.
Refer to 7-2-2 Replace the Fan Unit on page 7-7 to replace the Fan
Unit.
7 Maintenance
Reference
Reference
7
7-3