Power Off; Power Off Using The Power Button; Power Off Using The Power On/Off Input - Omron SYSMAC NY Series Hardware User Manual

6-3

Power OFF

This section provides Power OFF details.
Before following power OFF procedures below, check that the IPC Machine Controller is ON by exam-
ining the LED indicators on the Panel PC.
6-3-1

Power OFF Using the Power Button

1
Ensure all programs are closed.
If required close all active programs.
2
Press and release the power button on the Panel PC within 1 second.
Refer to 3-3 Power Button on page 3-14 for the power button location information.
The IPC Machine Controller will power OFF.
3
Wait until the PWR LED is OFF.
The IPC Machine Controller is powered OFF.
Additional Information
The IPC Machine Controller will be restarted by the UPS when powered off using the power
button, when the UPS is connected using the I/O Connector. Use the power button of the UPS
or remove the input power from the UPS for a normal shutdown of the system.
6-3-2

Power OFF Using the Power ON/OFF Input

1
Ensure all programs are closed.
If required, close all active programs.
2
Supply a 24 VDC signal to the Power ON/OFF Input (pins 3 and 4) of the I/O connector.
The input signal must remain ON for a minimum of 60 ms and a maximum of 750 ms to be
correctly detected by the Panel PC.
The IPC Machine Controller will power OFF.
3
Wait until the PWR LED is OFF.
The IPC Machine Controller is powered OFF.
Additional Information
• Refer to 4-2-2 I/O Connector Specifications on page 4-13 for connector specifications.
• Refer to 5-4-4 Wire the I/O Connector on page 5-37 for wiring details.
NY-series Industrial Panel PC Machine Controller Hardware User's Manual (W557)
6 Operating Procedures
6
6-5