Omron SYSMAC NY Series Hardware User Manual page 165

Power Connector Wiring Materials
Use the power supply connector that was supplied to connect the power supply to the IPC Machine
Controller.
• Select power supply conductors with consideration to the voltage drop and heat generation for the
cable length at the installation environment.
• Always use twisted wires to minimize the occurrence of electrical disturbance.
• Recommended power supply conductor sizes are provided in the table.
Solid conductor
Flexible conductor
Flexible conductor, with ferrule and no plastic sleeve
Flexible conductor, with ferrule and plastic sleeve
Minimum AWG according to UL/cUL
Maximum AWG according to UL/cUL
• Power Supply Connector
DC Power Supply
The OMRON S8VK-series power supply is recommended for use with the IPC Machine Controller.
Additional Information
• Refer to 3-10-9 Power Supply on page 3-32 for more information.
• Refer to 4-1-3 Power Consumption Specifications on page 4-5 for power consumption details.
NY-series Industrial Panel PC Machine Controller Hardware User's Manual (W557)
Wire type Conductor cross-section
2
0.5 to 10 mm
2
0.5 to 6 mm
2
0.5 to 6 mm
2
0.5 to 4 mm
20
8
5 Installation
5
5-35