Mount The Panel Pc - Omron SYSMAC NY Series Hardware User Manual

5 Installation
5-3-9

Mount the Panel PC

Ensure the panel cut out is ready before beginning the mounting procedure.
Tools required: Torque screw driver with hexagon 2 mm bit.
Use the following procedure to mount the Panel PC to the mounting surface:
1
Ensure all retractable mounting brackets A are in the retracted position
the mounting brackets in the retracted position and hand tighten the allen bolt
2
1
2
Insert the Panel PC into the mounting surface cut out so the bezel B touches the mounting
surface.
3
Loosen the allen bolts
The mounting brackets are spring loaded and will extend
4
Ensure all mounting brackets extend to overlap the mounting surface.
5
Tighten all mounting brackets to a torque of 0.6 N·m to maintain water and dust resistance.
Precautions for Safe Use
The mounting panel must be between 1.6 and 6.0 mm thick. Tighten the mounting brackets
evenly to a torque of 0.6 N·m to maintain water and dust resistance. If the tightening torque ex-
ceeds the specified value, or the tightening is not even, deformation of the front panel may oc-
cur. Additionally, make sure the panel is not dirty or warped and that it is strong enough to hold
the product.
5-26
B
3
2
of the mounting brackets.
NY-series Industrial Panel PC Machine Controller Hardware User's Manual (W557)
A
3
when loose.
1
. If required press
2
.