Maintenance And Care; Maintenance; Mechanical; Additional With Steel-Fingergrippers (Wb-Sq) - probst FTZ-MULTI Operating Instructions Manual

Maintenance and care

8 Maintenance and care
8.1

Maintenance

To ensure the correct function, safety and service life of the device the following points must be executed in the
maintenance interval.
Used only original spare parts, otherwise the warranty expires.
All operations may only be made in closed state of the device!
For all operations you have to make sure, that the device will not close unintended. Danger of injury!!!
8.2

mechanical

SERVICE INTERVAL
First inspection after
25 operating hours
All 50 operating hours
Minimum 1x per year
(at rough conditions shorten
the interval)
8.3

Additional with steel-fingergrippers (WB-SQ)

Before each start-up:
Regular:
Weekly:
AUTOMATIC-RELEASE
Never grease the automatic-release, if necessary use oil!
22 / 25
Maintenance work
●
Control and tighten all screws and connections.
(The implementation is only allowed by an expert).
●
Tighten all screws and connections (take care that the tightening torques according
to the property class of the screws are observed).
●
Check all existing safety elements (such as linchpins / safety clips) for perfect function
and replace defective safety elements.
●
Check all joints, bolts, guidance's and gears for correct function, if necessary adjust or
replace it.
●
Check all Grippers (if available) for signs of wear.
●
Grease all slidings (if available) when the device is in opened position with a spatula.
●
Grease all grease nipples (if available) with a grease gun.
●
Check of all the suspension parts, bolts and straps. Check for corrosion and safety by
an expert.
●
Check all steel-fingergrippers for mobility, abrasion and contamination.
Worn (no longer sharp-edged) or bent steel-fingergrippers must be replaced!
●
Cleaning of the device with high pressure cleaner (warm water).
●
Lubricate and oil mobile parts
V1
GB