Husqvarna AUTOMOWER 310 Operator's Manual page 52

always select the maximum cutting height the
first weeks after installation and then lower the
height one step at a time every second week until
the desired cutting height has been reached.
A defective splicing of the loop wire can also lead
to disruptions several weeks after the splice was
done. A faulty splice can, for example, be the
result of the original coupler not being pressed
together hard enough with a pair of pliers, or that
a coupler of lower quality than the original
coupler has been used. Please first check all
known splices before further troubleshooting is
done.
A wire break can be located by gradually halving
the distance of the loop where the break may
have occurred until there is only a very short
section of the wire left.
The following method does not work if
mode is activated. Make sure first that ECO
mode is switched off. Refer to ECO mode on
page 31 .
1. Check that the indicator lamp in the charging
station flashes blue, which indicates a break
in the boundary loop. Refer to
in the charging station on page 49 .
2. Check that the boundary wire connections to
the charging station are properly connected
and not damaged. Check that the indicator
lamp in the charging station is still flashing
blue.
POWER
AR
GUIDE
52 - Troubleshooting
3.
ECO
Indicator lamp
AL
Switch the connections between the guide
wire and the boundary wire in the charging
station.
Start by switching connection and .
If the indicator lamp has a solid green light,
then the break is somewhere on the
boundary wire between and the point where
the guide wire is connected to the boundary
wire (thick black line in the illustration).
AL
GUIDE
Guide
To rectify the fault you will need boundary
wire, connector(s) and coupler(s):
a) If the suspected boundary wire is short
then it is easiest to exchange all of the
boundary wire between and the point where
the guide wire is connected to the boundary
wire (thick black line).
b) If the suspected boundary wire is long
(thick black line) then do as follows: Put and
back to their original positions. Then
disconnect . Connect a new loop wire to .
Connect the other end of this new loop wire
at the middle of the suspected wire section.
1440 - 003 - 09.03.2020