Husqvarna AUTOMOWER 310 Operator's Manual page 27

2. Use the arrow buttons and the OK button to
move through the menu structure
timer > Use Weather timer .
3. Push the OK button to select the
timer .
4. Push the BACK button.
3.10.4.2 To set the Weather timer frequency
Set how frequently the product cuts the grass
when the Weather timer is in use. There are 3
Low, Mid and High . The higher
frequency levels:
the frequency, the more sensitive the product is
to the grass growth. That is, if the grass growth is
high then the product is allowed to work longer.
Note: If the mowing results are not optimal when
Weather timer , the schedule settings may
using
need adjusting. Do not restrict the schedule more
than necessary. Also, check that the blade disc is
clean and that the blades are in good condition.
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
timer > Cutting time .
3. Use the arrow buttons to select
High frequency.
4. Push the BACK button.
3.10.5 Lawn Coverage
If the work area includes remote parts that are
connected with narrow passages, the
Coverage function is useful to be able to maintain
a well-cut lawn in all parts of the yard. A guide
wire must be installed to use the functions. You
can set a maximum of 3 remote areas.
Lawn Coverage function the product first
With the
follows and then leaves the guide wire after a
certain distance and starts to mow the lawn.
Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
1440 - 003 - 09.03.2020
Weather
Weather
3.10.5.1 GPS Assisted Navigation
Only for Automower
The GPS Assisted Navigation function helps the
product to select the most optimal operation. Use
the Lawn coverage function to do manual
settings.
To set the GPS Assisted Navigation
Disable the GPS Assisted Navigation to make
Weather
manual settings in
Note: It is recommended to use GPS Assisted
Low, Mid or
Navigation.
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
Lawn
move through the menu structure
> Lawn coverage .
3. Push the OK button to enble or disable the
function.
4. Push the BACK button.
3.10.5.2 To set the Lawn Coverage function
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Lawn Coverage > Area 1-3 .
3. Use the arrow button to select the area.
4. Push the OK button.
5. Measure the distance from the charging
station to the start of the area. Measure
along the guide wire. Refer to
A
®
315X.
Lawn coverage .
To get access to the menu
To get access to the menu
Installation - 27
C
B
Installation
Installation
To measure