Husqvarna AUTOMOWER 310 Operator's Manual page 25

Product work ca- Approximate daily opera-
pacity tion capacity, m
®
Automower 310 56 / 603
®
Automower 315 68 / 732
®
Automower 315X 73 / 786
Example: A lawn of 500 m
®
Automower 310.
2
500 m / 56 ≈ 9 h.
2
5400 ft / 603 ≈ 9 h.
Days / week h / day
7 9
3.10.3.3 To copy the schedule setting
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Overview > Copy .
3. Use the arrow buttons and the OK button to
copy the schedule setting. You can copy the
schedule settings day to day or for the full
week.
3.10.3.4 To reset the schedule setting
You can remove all schedule settings and use
the factory setting.
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Overview > Reset .
a) Push the arrow buttons to select
Current day to only reset the current
day to factory settings.
1440 - 003 - 09.03.2020
2 2
/h, ft /h
2 2
/ 5400 ft , cut with a
Suggested
schedule setting
07:00- 16:00 /
7:00 am - 4:00
pm
Schedule
Schedule
b) Push the arrow buttons to select
week to reset all schedule settings to
factory settings.
3. Push the OK button.
3.10.3.5 Security level
There are 3 security levels for the product.
Function Low
Alarm
PIN-code
Time lock X
• Alarm - An alarm goes off if the PIN-code is
not entered within 10 seconds after the
STOP button is pushed. The alarm also
goes off when the product is lifted. The
alarm stops when the PIN-code is entered.
• PIN-code - The correct PIN-code must be
entered to get access to the Menu structure
of the product. If the incorrect PIN-code is
entered 5 times, the product is locked for a
time. The lock is extended for each new
incorrect try.
• Time lock - The product locks if the PIN-
code has not been entered in 30 days. Enter
the PIN-code to get access to the product.
To set the security level
Select 1 of 3 security levels for your product.
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Security > Security level .
3. Use the arrow buttons and the OK button to
select the level of security.
4. Push the OK button.
To create a New loop signal
The loop signal is randomly selected to create a
unique link between the product and the charging
station. In rare cases, there may be a need to
generate a new signal, for instance if two
adjacent installations have a very similar signal.
1. Place the product in the charging station.
All
Medium High
X
X X
X X
Settings >
Installation - 25