Husqvarna AUTOMOWER 310 Operator's Manual page 30

station, it always moves to the left of the guide
wire.
The corridor width is adjusted automatically. Only
in rare occasions manual settings need to be
entered. The corridor width can be set between
0-9. If guide corridor width is set to 0, the product
runs over the guide wire. The factory setting is 6
for the boundary wire and 9 for the guide wire.
3.10.7.1 To set the corridor width
1. Do steps 1–3 in To get access to the menu
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Advanced > Corridor width .
3. Use the arrow buttons to select a corridor.
4. Use the number buttons to select a corridor
width of 0-9.
Note: Make the corridor width as wide as
possible for a minimum risk of lines in the lawn.
3.10.8 Exit angle
Lawn Coverage function is less
If the sum of the
than 100%, the product sometimes starts to mow
at the charging station. The product moves away
from the charging station with an exit angle
between 90°–270°. The exit angles can be set to
1–2 exit sectors.
3.10.8.1 To set the exit angle
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Advanced > Exit angles > Sector 1 .
3. Use the number buttons to set the angles in
degrees.
30 - Installation
4. Push the down arrow button.
5. Use the number buttons to select how
frequently the product must use each sector.
Set in percentage.
6. Push the BACK button.
3.10.9 Reversing distance
The reversing distance makes the product move
in reverse for a set distance, before the product
starts to cut the lawn. The factory setting is 60
cm / 2 ft.
3.10.9.1 To set the reversing distance
1. Do steps 1-3 in
on page 24 .
2. Use the arrow button and the OK button to
move through the menu structure
> Advanced > Reversing distance .
3. Use the number buttons to set the distance.
4. Push the BACK button.
3.10.10 Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance before the
product moves back into the work area. The
Installation
factory setting is 31 cm / 13 in. You can select a
distance of 20-50 cm / 10-15 in.
Note: If the
the distance will change along the boundary wire
everywhere in the work area.
3.10.10.1 To set the Drive Past Wire function
1. Do steps 1–3 in
on page 24 .
2. Use the arrow button and the OK button to
move through the menu structure
> Advanced > Drive Past Wire .
3. Use the number buttons to set the distance.
4. Push the BACK button.
3.10.11 Settings
Installation
In settings you can change the general settings
to your product.
To get access to the menu
Drive Past Wire distance is changed,
To get access to the menu
1440 - 003 - 09.03.2020
Installation
Installation