Husqvarna AUTOMOWER 310 Operator's Manual page 21

WARNING: Do not put the power
supply at a height where there is a risk
it can be put in water. Do not put the
power supply on the ground.
WARNING: Do not encapsulate the
power supply. Condensed water can
harm the power supply and increase
the risk of electrical shock.
WARNING: Risk of Electric Shock.
Install only to an residual-current
device when connecting the power
supply to the wall socket. Applicable to
USA/Canada. If power supply is
installed outdoors: Risk of Electric
Shock. Install only to a covered Class
A GFCI receptacle (residual-current
device) that has an enclosure that is
weatherproof with the attachment plug
cap inserted or removed.
CAUTION: Do not make new holes in
the charging station plate.
CAUTION: Do not put your feet on the
baseplate of the charging station.
WARNING: The power supply cable
and the extension cable must be
outside the work area to avoid damage
to the cables.
When connecting the power supply, only use a
wall socket that is connected to an residual-
current device.
1. Read and understand the instructions about
the charging station. Refer to
where to put the charging station on page
15 .
2. Put the charging station in the selected area.
Note: Do not attach the charging station to
the ground with the screws until the guide
1440 - 003 - 09.03.2020
wire is installed. Refer to
wire on page 22 .
3. Connect the low-voltage cable to the
charging station.
4. Put the power supply at a minimum height of
30 cm / 12 in.
5. Connect the power supply cable to a
100-240V power outlet.
Note: When the charging station is
connected, it is possible to charge the
product. Place the product in the charging
station while the boundary and guide wires
are being laid. Switch on the product. Do not
continue with any product settings before
the installation is complete.
6. Put the low-voltage cable in the ground with
stakes or bury the cable. Refer to
wire into position with stakes on page 22 or
To bury the boundary wire or the guide wire
on page 23 .
7. Connect the wires to the charging station
after the installation of boundary wire and
guide wire is complete. Refer to
the boundary wire on page 21 and To
install the guide wire on page 22 .
8. Attach the charging station to the ground
with the supplied screws after the guide wire
is installed. Refer to
on page 22 .
3.5.3 To install the boundary wire
To examine
1. Put the boundary wire around all of the work
area. Start and complete the installation
behind the charging station.
To install the guide
min 30 cm / 12"
To install the guide wire
CAUTION: Do not put remaining wire
in a coil. The coil causes interference
with the product.
Installation - 21
To put the
To install