Husqvarna AUTOMOWER 310 Operator's Manual page 46

Message Cause
Electronic problem Temporary electronic or firmware rela-
ted issue in the product.
Loop sensor prob-
lem, front/rear
Tilt sensor prob-
lem
Temporary prob-
lem
Invalid sub-device
combination
Temporary battery
problem
Charging system
Incorrect type of battery.
problem
Battery problem
Temporary battery or firmware related
issue in the product.
Incorrect type of battery.
Battery tempera-
The temperature in the battery is too
ture outside limits high or too low to start operation.
Charging current
Wrong or faulty power supply unit.
too high
Connectivity prob-
Potential problem on the connectivity
lem
circuit board in the product.
Connectivity set- The connectivity settings was restored
tings restored
due to a fault.
Poor signal quality The connectivity circuit board in the
product is assembled upside down, or
the product itself is tilted or upside
down.
46 - Troubleshooting
Action
Restart the product. If the problem
stays speak to your authorized service
technician.
Use original batteries recommended by
the manufacturer.
Restart the product. If the problem
stays speak to your authorized service
technician.
Use original batteries recommended by
the manufacturer.
No action. The product will start to op-
erate when the temperature is in limits.
Restart the product. If the problem
stays speak to your authorized service
technician.
Restart the product. If the problem
stays speak to your authorized service
technician.
Check and change the settings if nee-
ded.
Make sure that the product is not up-
side down or tilted. If the problem stays
speak to your authorized service tech-
nician.
1440 - 003 - 09.03.2020