Husqvarna AUTOMOWER 310 Operator's Manual page 29

irregular method for 3 min. After 3 min the
product changes search method to the guide wire
method. The product tries to find the guide wire
for 8 min. After 11 min the product changes
search method to the boundary wire method.
You can change the settings for how the product
finds the charging station to adapt to the work
area.
3.10.6.1 To set how the product finds the
charging station
You can make manual settings to make the
product search for the guide wire or the boundary
wire in 0–30 min from when the battery is low.
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> To find the charging station > Overview of
search methods > Guide .
3. Push the arrow buttons to select 1 of the
guide wires.
4. Push the number buttons to set the time.
5. Push the OK button.
6. Push the BACK button.
7. Use the arrow buttons and the OK button to
move through the menu structure
> To find the charging station > Overview of
search methods > Boundary wire .
8. Push the number buttons to set the time.
9. Push the OK button.
10. Push the START button and close the hatch.
3.10.6.2 To do a test of the guide wire
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Find charging station > Guide > More >
Test guide .
3. Put the product 3 m / 9 ft. from the boundary
wire.
4. Push the START button and close the hatch.
5. Make sure the product follows the guide wire
to the charging station.
6. Make sure the product docks with the
charging station.
1440 - 003 - 09.03.2020
7. If the product does not dock with the
charging station, change the position of the
charging station or the guide wire. Refer to
To install the charging station on page 20
To install the guide wire on page 22 .
and
3.10.6.3 To do a test of the boundary wire
1. Put the product 3 m / 9 ft. from the boundary
wire, facing the boundary wire.
2. Do steps 1–3 in
on page 24 .
3. Use the arrow buttons and the OK button to
move through the menu structure
> Find charging station > Overview of
search methods > Boundary > More > Test
right / Test left .
4. Push the START button and close the hatch.
Installation 5. Make sure the product follows the guide wire
to the charging station.
6. Make sure the product docks with the
charging station.
7. Change the position of the charging station
or the guide wire if the product does not
dock with the charging station. Refer to
install the charging station on page 20 and
To install the guide wire on page 22 .
3.10.6.4 To change the signal range of the
Installation
charging station
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Find the charging station > Overview of
search methods > Charging station range .
3. Use the left arrow button to select
MID, MIN .
4. Push the BACK button.
Installation
Note: It is usually better to move the charging
station, than to decrease the range of the
charging station signal.
3.10.7 Corridor width
The boundary wire corridor is the area adjacent
to the boundary wire and the guide corridor is the
area adjacent to the guide wire. The product uses
the corridors to find the charging station. When
the product moves in the direction of the charging
To get access to the menu
Installation
To
To get access to the menu
Installation
MAX,
Installation - 29