Husqvarna AUTOMOWER 310 Operator's Manual page 31

3.10.11.1 Profiles
With the function Profiles, different sets of
product settings can be saved. This can be used
when one product is used for more than one work
areas and charging stations. The product settings
and the pairing with the charging stations are
saved in the profile and can easily be used again.
To save settings to a profile
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Profiles > Use profiles > Profile A, B, C.
3. Use the arrow buttons and the OK button to
select and save the profile.
4. Push the BACK button.
If settings have been changed but not saved, the
symbol * is shown beside the profile name.
To change the name of a profile
1. Do steps 1–3 in To get access to the menu
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure Settings
Profiles > Use profiles > Profile A, B, C. >
Rename.
3. Use the arrow buttons and the OK button to
select letters.
4. Push the BACK button to save the new
profile name.
To use a profile
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Profiles > Use profiles > Profile A, B, C >
Select.
3. Push the BACK button.
To connect a new charging station to a profile
1. Save the settings in a profile to be used with
the original charging station. Do steps 1–4 in
To save settings to a profile on page 31 .
2. Put the product in the new charging station.
3. Use the arrow buttons and the OK button to
move through the menu structure
Advanced > New loop signal .
1440 - 003 - 09.03.2020
4. Save a profile for the new charging station,
or select a profile in the list. Do steps 1–4 in
To save settings to a profile on page 31 , or
do steps 1–3 in
3.10.12 ECO mode
ECO mode is activated, it switches off the
If
signal in the boundary loop, the guide wire and
the charging station, when the product is parked
or is charging.
Note: Use
interference with other equipment, for example
Settings >
hearing loops or garage doors.
Note: To start the product manually in the work
area, push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
3.10.12.1 To set the ECO mode
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
>
move through the menu structure
ECO mode .
3. Push the OK button to select the
mode .
4. Push the BACK button.
3.10.12.2 Spiral Cutting
The product cuts the grass in a spiral pattern if
the grass is longer in an area.
be set in 5 levels:
• Low-
• Low
Settings >
• Mid
• High
• High+
The level sets how sensitive the product is to
changes in grass height.
Spiral cutting is only started in the Main
Note:
area mode. Cutting in the
does not let the product to start
Spiral Cutting does not start in slopes steeper
Security > than 15%.
To set the Spiral Cutting
To use a profile on page 31 .
ECO mode to save energy and avoid
To get access to the menu
Spiral cutting can
Secondary area mode
Spiral cutting .
Installation - 31
Settings >
ECO