Find Breaks In The Loop Wire - Husqvarna AUTOMOWER 310 Operator's Manual

Symptoms Cause
Both the mowing The battery is spent.
and charging times
are shorter than
usual.
The product is The product has an inbuilt standby peri-
parked for hours in od according to the Standby time table.
the charging sta- Refer to
page 37 .
tion.
The hatch is closed but the START but-
ton is not pushed.
Parking mode is activated.
The product is not allowed to operate if
the battery temperature is too high or
too low.
Uneven mowing The product works too few hours per
results. day.
The shape of the work area requires
the use of
the product to find its way to all remote
areas.
The
relation to the layout of the work area.
The work area is too large.
Dull blades.
Long grass in relation to the set cutting
height.
Accumulation of grass by the blade
disc or around the motor shaft.

6.6 Find breaks in the loop wire

Breaks in the loop wire are usually the result of
unintentional physical damage to the wire such
as when gardening with a shovel. In countries
with ground frost, also sharp stones that move in
the ground can damage the wire. Breaks can
1440 - 003 - 09.03.2020
Schedule and Standby on
Lawn coverage function for
How often? setting is incorrect in
Action
Replace the battery. Refer to
on page 41 .
No action.
Push the STOP button to open the
hatch. Enter the PIN code and confirm
with the OK button. Push the START
button and then close the hatch.
Change the operating mode. Refer to
Operating mode Start on page 36 .
Check that the charging station is
placed in an area with protection from
the sun.
Increase the mowing time. Refer to
Schedule on page 24 .
Steer the product to a remote area. Re-
Lawn Coverage on page 27 .
fer to
Check that the correct
ue is selected.
Try limiting the work area or extending
the schedule. Refer to
page 24 .
Replace all the blades. Refer to
place the blades on page 41 .
Increase the cutting height and then
successively lower it.
Check that the blade disc rotates freely
and easily. If not, screw off the blade
disc and remove grass and foreign ob-
Chassis and blade disc
jects. Refer to
on page 40 .
also occur due to the wire being stretched
excessively during installation.
Mowing the grass too low right after the
installation can damage wire insulation. Damage
to the insulation may not cause disruptions until
several weeks or months later. To avoid this,
Battery
How often? val-
Schedule on
Re-
Troubleshooting - 51