1.
Set the Main switch to position
2.
Place the product in the charging station.
Slide the product in as far as possible to
ensure proper contact between the product
and the charging station. Refer to contact
and charging plates in
®
Automower
310/315/315X on page 4
3.
The display shows a message that charging
is in progress.
4.9 Adjust the cutting height
CAUTION: During the first weeks after
a new installation, the cutting height
must be set to MAX to avoid damaging
the loop wire. After this, the cutting
height can be lowered step by step
every week until the desired cutting
height has been reached.
The cutting height can be varied from MIN (2 cm /
0.8 in.) to MAX (6 cm / 2.4 in.).
4.9.1 To adjust the cutting height
1.
Push the STOP button to stop the product.
2.
Open the hatch.
3.
Turn the knob to the required position.
•
Turn clockwise to increase the cutting
height.
•
Turn counter-clockwise to decrease the
cutting height.
4.
Close the hatch.
1440 - 003 - 09.03.2020
1 .
Product overview
Operation - 39