Maintenance; Maintenance Schedule For The Service Center - Husqvarna R112C Workshop Manual

6.1 Maintenance schedule for the service
center
1. PREPARE THE PRODUCT
Do a check of the battery.
Do a check of the blades.
Do a check of the belts and pulleys.
Do a check of the steering chain of the inner side of the frame tunnel.
Do an inspection, lubricate and adjust all wires.
Make sure that all screws and nuts are tightened with the correct torque.
Lubricate the operators seat.
Lubricate the wheels and blade bearings on the cutting deck.
Lubricate the pedals on the inner side of the frame tunnel.
Lubricate the belt tensioners.
2. ENGINE
Do a check of the fuel hose. Replace if it is necessary.
Replace the fuel filter.
Replace the prefilter and paper filter in the air filter.
Clean the engine and the hydrostatic transmission.
Do an inspection of the cooling fins on the hydrostatic transmission.
Do a check of the muffler and the heat deflector.
Replace the engine oil. Refer to
Replace the engine oil filter.
Replace the spark plug.
Do a check of the battery and charge if it is necessary.
3. TRANSMISSION, CONTROLS AND DRIVE SYSTEM
Make sure that the tire pressure is correct. Refer to
Examine and adjust the parking brake.
1342 - 002 -

6 Maintenance

To replace the engine oil on page 31 .
Wheels on page 8 .
First servicing Maintenance
interval in
hours
50 100
O
O
O O
O
O
O
O
O O
O
O
First servicing Maintenance
interval in
hours
50 100
O
O
Clean O
O
O
O O
O O
O O
O
O O
First servicing Maintenance
interval in
hours
50 100
O O
O O
Maintenance - 13