Service; Service Schedule; Screw Fasteners - Husqvarna GARDENA SILENO MINIMO Workshop Manual

6.1 Service schedule

The table below contains a checklist of points and actions to be taken when servicing the product. Complete service
plans can be found in Autocheck.
Every Every Action
year 3rd year
Remove the body and clean the chassis.
X
Check the ventilation filter and clean carefully
X
with a soft brush.
Check the tightening torque of screws on the
X
chassis.
Check the blades and blade screws.
X
X Clean the charging station.
Check and polish the charging plates on the
X product and the contact plates on the charging
station.
X Make a complete
Check that docking and charging work correct-
X
ly.
Do a
X
battery condition.
Charge the battery.
X
Read the service bulletins for potential recom-
X
mended updates.
Replace the ventilation filter.
X
Open the chassis and replace the chassis seal-
X
ing strips.

6.2 Screw fasteners

All screws are made from stainless material or rustproofed with zinc plating. Article numbers are found in the spare
parts list (IPL).

22 - Service

Auto test in Autocheck.
Battery test in Autocheck and check the
6 Service
Explanation
Refer to
on page 13 .
Refer to
ter on page 18 .
Refer to
Refer to
the Operator's manual.
Polish contact surfaces on both the product and
the charging station with a fine grade emery
cloth.
Refer to
Refer to
Symptoms during charging on page 30 .
and
Refer to
Always charge the battery fully before winter
storage. If this is not done, the battery may be
rendered useless due to voltage levels drop-
ping too low.
Updated service bulletins can be found in Au-
tocheck.
Refer to
ter on page 18 .
Refer to
20 .
To remove and install the body system
To clean and replace the ventilation fil-
Screw fasteners on page 22 .
Maintenance - Replace the blades. in
Auto test on page 10 .
Symptoms during docking on page 29
Auto test on page 10 .
To clean and replace the ventilation fil-
To replace the sealing strips on page
1595 - 001 - 01.02.2021