Husqvarna Rider 11 Workshop Manual page 41

8
4
Fully depress the hydrostatic transmission pedal
and secure it with a cable tie to set the correct wire
tension for maximum speed.
Adjust the ball joint and press it onto the ball, with
the control arm pushed in as far as it will go.
Tighten the lock nut and refit the wire clip.
9
Secure the cables to the rear clip using a cable tie.
3
2
1
10
Secure the transmission wire with a cable tie.
11
Tighten the lock nut on the transmission wire front
ball joint.
12
Refit the frame plate using the four screws.
Reparation instructions
~80
39
English –