Belt replacement on cutting unit's with side or
rear ejectors
1
• Remove the cutting unit.
• Remove the bolt holding the parallel strut and the
two screws on the deck.
2
Cutting units with side or rear ejectors are powered
by one V-belt. Proceed as follows to replace the
V-belt:
• Loosen the spring that tensions the V-belt and
pry off the belt.
• To fit a new belt, follow the instructions above in
the reverse order.
Removal of blades with bearings
!
WARNING!
When working with the mowing
deck, use protective glasses and
gloves.
1
• Release the spring which tensions the V-belt and
twist off the belt.
• Unscrew the screw which holds the pulley (2)
and detach the pulley, a puller may be needed
for this. Do not lose the key which is found
between the pulley and the axle.
2
Unscrew the screw which holds the blade and
remove the screw, washer and blade.
Reparation instructions
53
English –