Removal Of Swing Axle - Husqvarna Rider 11 Workshop Manual

Reparation instructions
5
Remove the inner circlip (1) from the lower bearing
(see diagram). The rear section is now loose and
can be moved. Then detach the outer circlip (2) and
take the bearing out downwards.
6
• Take the upper bearing out upwards, if it does not
come out easily, it should be knocked out from
below.
• Insert the new bearings and assemble the
articulated steering in the reverse removal order.
• After re-assembly, the wire tension should be
checked (see "Checking and adjusting steering
wires"). Also check that the controls and wires
are correctly adjusted.
28
– English

Removal of swing axle

1
• Block-up the machine in front of the rear frame.
• Remove the transmission/gear box cover.
2
• Detach the tensioning wheel spring (1) and the
clutch wire (2).
• Disconnect the tensioning wheel arm (3) from
the rear frame, and detach the belt from the gear
box pulley.
• Detach the gear and brake wires (4 and 5) and
remove the wires' holding plates (6).
• Remove the circlip and washer from the swing
axlel (7) and pull the rear frame out backwards.