Reparation instructions
Removing the cutting unit
Rider 11 Bio, Rider 13 H Bio, Rider 14 Pro and
Rider 16 H
1
• Apply the parking brake.
• Adjust the cutting height to its lowest setting.
• Remove the front cover.
2
Fit the support wheels.
!
WARNING!
Wear protective glasses when
removing the cutting unit. The
spring which tensions up the belt
can go off and cause personal
injury.
48
– English
3
Relieve the tensioning wheel by disconnecting the
spring.
4
Lift the drive belt off the cutting unit drive pulley.
5
Pull out the pin.