Hydrostatic Transmission Brake; Removal Of Brake; Installation Of Brake - Husqvarna Rider 11 Workshop Manual

Reparation instructions

Hydrostatic transmission brake

Removal of brake

1
• Place blocks in front of and behind the wheels so
that the ride-on mower can not roll. Then, release
the parking brake.
• Remove the split pin and the washer from the
brake's connecting rod (1).
• Remove the three bolts and washers (2) from the
transmission and detach the brake lining packet.
2
Remove the brake drum by removing the circlip and
pulling the drum outwards.
IMPORTANT INFORMATION
It is seldom necessary to remove the
brake drum. If, however, it needs to be
removed, a puller and/or penetrating oil is
needed to get it off.
40
– English

Installation of brake

1
• Put the brake drum on the axle and attach the
circlip.
• Assemble the brake lining packet on the trans-
mission and tighten the three bolts and washers
by hand .
• Press the brake lever (1) backwards so that the
brake lining locks the drum, and draw the three
bolts with moment to 27 Nm (20 ft, lbs.), whilst
the drum is locked.
2
Install the brake spring with holder on the gold-
coloured brake arm by passing the recesses into
the holder with metal tabs on the brake arm. Then,
turn the holder in towards the transmission.
IMPORTANT INFORMATION
Firmly fix the spring holder so that the
holder's metal tabs (shown by the arrows)
point away from the transmission.